Connect to the Internet via an ethernet cable¶

To access the Internet, it can connect the WAN port of router to the modem or the LAN port of other router via an ethernet cable.

On the left side of web Admin Panel -> INTERNET, Ethernet sector.

ethernet dhcp

Note: Before plugging the Ethernet cable into the WAN port of the router, you can click Change to LAN to set the WAN port as a LAN port. That is useful when you are using the router as a repeater. As a result, you can have one more LAN port.

Protocol¶

There are 3 types of protocols, DHCP, Static, PPPoE. Click Modify to change.

DHCP

DHCP is the default and most common protocol. It is a network management protocol used on Internet Protocol (IP) networks for automatically assigning IP addresses and other communication parameters to devices connected to the network using a client–server architecture.
Static

Static is required if your Internet Service Provider (ISP) has provided a fixed IP address for you or you want to configure the network information such as IP address, Gateway, Netmask manually.
PPPoE

PPPoE is required by many Internet Service Providers (ISP). Generally, your ISP will give you a modem and provide you a username & password that you needed when you are creating the Internet connection.

VLAN ID: This settings entry is only required if the provider's PPPoE server requires the interface to use a tagged specific VLAN ID.

Warning¶

When Internet access is not available, the corresponding warning is displayed. To determine whether you can access the Internet or not, please go to Multi-WAN page.

Warning: The interface is connected, but the Internet can't be accessed with IPv4 protocol.

Solution: Please check if the upstream device of Ethernet has internet access.