Skip to content

Stuck on the "Reverting" screen when resetting the router's firmware

If you are stuck on the "Reverting" screen when resetting your router's firmware, refer to the following steps to resolve the issue.

stuck on reverting

After each step, check if the issue is resolved. If the issue is resolved, you can skip the rest of the steps.

  1. Wait for at least 10 minutes to see if the reverting process completes on its own. The reverting process can sometimes take longer than expected.

  2. If the reverting process does not complete after 10 minutes, power off your router by unplugging the power cable. Wait for 30 seconds, then plug the power cable back in and wait for the router to boot up.

  3. In a web browser, enter 192.168.8.1. If the reverting process was successful, you will be directed to the setup guide.

  4. Enable the private/incognito mode of your browser, enter 192.168.8.1. If the reverting process was successful, you will be directed to the setup guide.

  5. Use a different browser (e.g., Chrome, Edge, Safari) to enter 192.168.8.1. If the reverting process was successful, you will be directed to the setup guide.

  6. If you still cannot access the router's web Admin Panel or the router is not functioning properly, try resetting the router to its factory default settings by follow this guide.

Still have questions? Visit our Community Forum.