How to integrate GL-S10 into Home Assistant¶

1.Introduction¶

GL-S10(ESPhome) is a firmware version compiled with ESPHome.

GL-S10 can be used as a Bluetooth proxy to automatically discover surrounding Bluetooth devices and you can use S10 to easily integrate into your homeassistant.

2.Connecting your GL-S10¶

First, plug in the power cord and the power indicator will light up. Then watch for the network indicator light to start flashing, indicating that GL-S10-esphome is starting up normally.

Second, plug in the Ethernet cable and you're ready to configure the GL-S10 on the Home Assistant.

3.Install Home Assistant Operating System¶

The Home Assistant has given detailed installation documentation for various conditions.

4.Onboarding Home Assistant and integrate GL-S10¶

Make sure your GL-S10 and Home Assistant are connected to the same Internet band.

After successfully installing and booting the Home Assistant operating system, you can access Home Assistant by going to homeassistant.local:8123. If you are using an older version of Windows or have a more restrictive network setup, you may need to access it at homeassistant:8123 or http://X.X.X.X:8123 (replace X.X.X.X with your ’s IP address).

For detailed onboarding instructions, click here.

When you reach the step shown in the image, you will see the gl-s10-bt-proxy option and can proceed to configure it.

The GL-S10 has been successfully added to your Home Assistant when you see the network indicator turn off.

s10_discoverd

You can see it on the dashboard by Settings.

dashboard_setting

dashboard_configuration